4000 AVE. PINARD,
ST-HYACINTHE,
QUÉBEC, CANADA,
J2S 8K4,
TEL: 450-383-4000,
FAX: 450-383-4004
www.ventecventilation.com
Sept. 8, 2016
PAGE 12 OF 17
REV 4
5
ASSEMBLY REQUIRED WITH THE CYCLONE IN THE AIR
5.1
DEFLECTOR SUPPORT BRACKETS
Deflector support Brackets are to be installed inside and on opposite flat sides of the cyclone housing. The
brackets are located on the sides that have a curved edge contour with holes drilled to mount the deflector brackets.
Use (12) M6 x 30mm bolts, (12) M6 hex nuts, (12) 6mm lock washers and (24) 6mm x 18mm flat washers to mount
the deflector brackets.
Install the turning vanes in-between the brackets with the (24) M8 x 25mm bolts, and (24) 8mm x 25mm flat
-way
-
rflow (See Figures 9 and 10).
Finger thread and snug these M8 bolts being careful not to over tighten. When you have completed setting the
deflector angles you must wrench tighten these bolts to
no
more
than
20
ft.-lbs.
Refer to fan adjustments in the start-up section.
Figu
re 9 -
Position
and
locati
on
of
th
e
hard
ware
on
th
e
Cyclon
e
Plus
ÄÃÂÁ-ÀA Ȁ
Figure
10
-
Position
and
locati
on
of
the
hardware
on
the
Cyclone
Plus
ÄĀÀÃ-ÀA Ȁ
PUTTING INNOVATION TO WORK
7686 16 Line, Arthur, ON.
N0G 1A0
Email: agsales@canarm.ca
Tel: 1-800-263-5314
Fax: 519-848-3948
www.canarm.com
Summary of Contents for AgSystem CYCLONE PLUS
Page 2: ......
