INSTALLATION AND MAINTENANCE INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Page 2 of 3
WWW.CANARM.COM
These instructions are for your safety. Read all these instructions before attempting to operate this
product and save these instructions. Do not use fan if any part is missing or damaged.
Warning
: To reduce the risk of fire or electrical shock, DO NOT use this fan with any solid state speed control device. This appliance
has a 3-prong grounded plug that must be inserted into a matching outlet. To reduce the risk of electrical shock, this grounded plug
must not be cut off the plug. Where a two-prong wall outlet is encountered, it must be replaced: contact a qualified electrician. DO
NOT attempt to defeat this safety feature. Use your fan only with adequate wiring that is up to Code. Connect to properly grounded
outlets only.
Rules for Safe Operation
• Always unplug unit for cleaning.
• Always unplug unit when not in use.
• Always unplug when moving unit from one location to another.
• Do not place foreign objects through guard into the blade.
• Do not operate without fan guards properly locked.
• Do not use with extension cord.
• Do not use fan in windows. Rain and moisture may create an electrical hazard.
• Do not place fan or any parts near an open flame, cooking or other heating appliance.
• Do not operate this unit with a damaged cord or plug, especially when this unit has been malfunctioned, dropped or damaged.
Unpack Your Fan and Check the Contents
• Motor Assembly
• Rear/Front Grille & Blade
• Wall Mounting Pipe & Bracket
Wall Mounting Base on a Wood Framed Wall
1. Locate a wall stud secure and solid enough to hold the weight of the assembled fan. Carefully locate and mark the center of
the wall stud. If you do not have a solid structural framing member at the desired location then you must provide an adequate
alternative for mounting the fan.
2. Place mounting base against the wall centered with the centerline of the wall stud.
3. Drill 3 holes on the wall and secure mounting base to wall using suitable hardware for wall material. If mounting on a con
crete wall, be sure to locate a structurally solid and secure location to hold the weight of the fan assembly and use suitable
concrete anchors to mount the base to the wall.
Base / Mounting Pipe Assembly
1. Put one end of the pipe into the slot in the base.
2. Tighten screws provided to hold pipe in place.
CAUTION: BE SURE TO SECURE THE SCREWS
HAF-W 11/20
