Canarm PALISADE, Installation Instructions Manual

pg. 5

REMEMBER

 to turn off the power. Follow 

the steps below to hang your fan properly:

Step 1. Remove the decorative canopy 
bottom cover from the canopy by turning 
the cover counter clockwise. (Fig. 5)

Step 2. Remove the hanger bracket from 
the canopy by removing the 1 of 2 screws 
from the bottom of the hanger bracket and 
loosening the other one a half turn from the 
screw head. Next, turn the canopy counter 
clockwise to removing the hanger bracket 
from the canopy. (Fig. 5)

Step 3. Pass the 120-volt supply wires 
through the center hole in the ceiling 
hanger bracket as shown in Fig. 6.

Step 4. Secure the hanger bracket to the 
ceiling outlet box with the screws and 
washers provided with your outlet box.

Step 5. Remove the hanger pin, lock pin 
and set screws from the top of the motor 
assembly.

Step 6. Route wires exiting from the top of 
the fan motor through the coupling cover, 
canopy cover, canopy and then through 
the ball / downrod. (Fig. 7)

Step 7. Align the holes at the bottom of the 
downrod with the holes in the collar on top 
of the motor housing (Fig. 7). Carefully 
insert the hanger pin through the holes in 
the collar and downrod. Be careful not to 
jam the pin against the wiring inside the 
downrod. Insert the locking pin through the 
hole near the end of the hanger pin until it 
snaps into its locked position. (Fig. 7)

Step 8. Tighten two set screws on top of 
the fan motor firmly. (Fig. 7)

Step 9. Place the downrod ball into the 
hanger bracket socket. Make sure the tab 
on the mounting bracket socket is properly 
seated in the groove in the hanger ball. 
(Fig. 8)

5. HANGING THE FAN

Figure 5

Figure 6

Figure 7

Figure 8

Registration slot

Downrod

Canopy

Set screws

Hanger pin

Lock pin

Canopy cover

Hanger 

bracket

Ceiling 

canopy

Canopy

cover 

Coupling cover

Mounting screws 
(supplied with 
electrical box)

CUL Listed 
electrial 
box

Hanger 
bracket

Tab