16
Canarm Tri-Lite 3LMPEC Series
5
MOUNTING METHOD 2: ANGLE IRONS
5.7 Attach Upper Yoke (to Angle Iron):
Secure the upper yoke directly to the angle irons with the Beam Clamp hardware as depicted below.
Consult the diagrams below for distances between the angle irons. Do not install the fan from a single
purlin, truss, or bar joist.
Tighten bolts to 90 ft-lb (122 N-m) using a 3/4” socket and torque wrench.
Upper Yolk Hardware (supplied):
a.
(4) 1/2”-13x2-1/2” GR 5 Bolt
b.
(8) 1/2” Flat Washer
c.
(4) 1/2”-13 Nylock Nut
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
Page. 16
DRAWN DATE:
XX.XX.XX
DRAWN BY:
XX
PART NUMBER:
XXXX
REV:
_001
THIS DRAWING IS THE EXCLUSIVE PROPERTY OF SKYBLADE FAN COMPANY AND CANNOT BE REPRODUCED OR
DISCLOSED TO ANY THIRD PARTY WITHOUT THE AUTHORIZATION OF SKYBLADE FAN COMPANY
MATERIAL:
XXXXXXXX
ALL DIMENSION ARE IN INCHES
UNLESS OTHERWISE STATED
a
b
b
c
Upper Yoke Side View
Upper Yoke Top View
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
Page. 16
DRAWN DATE:
XX.XX.XX
DRAWN BY:
XX
PART NUMBER:
XXXX
REV:
_001
THIS DRAWING IS THE EXCLUSIVE PROPERTY OF SKYBLADE FAN COMPANY AND CANNOT BE REPRODUCED OR
DISCLOSED TO ANY THIRD PARTY WITHOUT THE AUTHORIZATION OF SKYBLADE FAN COMPANY
MATERIAL:
XXXXXXXX
ALL DIMENSION ARE IN INCHES
UNLESS OTHERWISE STATED
The angle irons should be aligned with the innermost holes of the upper yoke.
Les fers angulaires doivent être alignés avec les trous les plus à l’intérieur de la culasse supérieure.
After attaching upper yoke to the angle irons, tighten all the bolts securing the angle irons to the roof
structure to 90 ft-lb (122 N-m) using a 3/4” socket with torque wrench.
Après l’avoir fixée culasse supérieure aux cornières, serrer tous les boulons de fixation des cornières à la
structure du toit à 90 lb-pi (122 Nm) avec une “prise 3/4 avec une clé dynamométrique.
CAUTION/ATTENTION
!
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
Page. 16
DRAWN DATE:
XX.XX.XX
DRAWN BY:
XX
PART NUMBER:
XXXX
REV:
_001
THIS DRAWING IS THE EXCLUSIVE PROPERTY OF SKYBLADE FAN COMPANY AND CANNOT BE REPRODUCED OR
DISCLOSED TO ANY THIRD PARTY WITHOUT THE AUTHORIZATION OF SKYBLADE FAN COMPANY
MATERIAL:
XXXXXXXX
ALL DIMENSION ARE IN INCHES
UNLESS OTHERWISE STATED
4.00”
(10.61 cm)
8-1/4”
(20.96 cm)
