Section 4 ‒ MultiLogger Configuration
36
MLTDR-W-50S User's Guide
Customize TDR200/SDMX50 Programming
The last step is to customize the programming being used for the
TDR200/SDMX50
. There are several
parameters that must be configured for each cable, dependent on the application.
Press the gear button to the left of the
Data Output
option to edit the programming, it will be loaded into
MLEditor
for modification.
Note the TDR200 instructions for each coaxial cable, 8 in total.
(The TDR200 instructions for the 8 channels, as shown in MLEditor)
By default, Channels 2-8 are commented out, and inactive. If the SDMX50/SDM8X50 is being used, the extra
channels must be made active by removing the apostrophe from the beginning of the three lines highlighted for
each channel being used.