Integrating the Yieldpoint d-Exto MPBX
2
System Wiring and Configuration
A converter is typically required to convert the RS-485 output of the d-Exto to RS-232. The example wiring in
Figure 2 outlines connecting a d-Exto to a Campbell Scientific
CR1000 using the RSCOM2A converter from
RE Smith. The RSCOM2A provides a low-cost, highly configurable signal converter.
(Figure 2)
Note: Two of the internal jumpers must be moved to from their factory positions to function properly with the d-Exto.
(Figure 3)
Campbell Scientific
is a registered trademark of Campbell Scientific, Inc.