Cleaning and Maintenance
The mouthpiece of the V5.0S Mini PRO may become clogged when used for an extended amount of
time; resulting in difficult draw resistance or less vapor being released. Use the following guidelines to
clean and maintain your device:
Ceramic heating chamber: Use the brush tool to gently clean the walls of heating chamber.
Ceramic Filter: Use a fine paperclip or pin and gently insert between the holes. Push through
thoroughly to clear the airway then wipe clean with a lint free cloth.
Mouthpiece: Carefully remove glass mouthpiece from device, wash gently with warm water, rinse
and air dry. For stubborn stains, rug gently with a damp cotton swab.
Tips
For best results, do not over-pack the ceramic heating chamber with your product. Over-packing will
cause constricted air flow and uneven vaping.
After filling, use the packing tool to gently stir and aerate the product to ensure vapor is released.
Always properly prepare the device before use to reduce blockage of the mouthpice.
Regulate airflow to the chamber using the slider at bottom of the V5.0S Mini PRO. Enhances custom
vaping. Take the mess out of grinding and loading your blend with our Load'X Grinder and Loader.
Sold separately.
Battery and Charging CHARGING
Initially charge the V5.0S Mini PRO for 3.5 to 4 hours. The battery will stop charging when the icon is
full. When the battery level is low, charge battery with included Micro 5 Pin USB Charing cable. Low
battery level will be indicated with battery icon flashing 6 times repeatedly.
Charging the V5.0S Mini PRO while powered on, the OLED display will stay lit.
Below is the chart of charging with device powered on
Charging the V5.0S Mini PRO while powered off, only the battery icon will be visible. Below is the chart
of charging with device powered off
Do not use V5.0S Mini PRO while charging. This will cause damage to the device.
To prevent the device from overheating, do not leave the charger plugged in overnight.
Do not leave charger plugged in our unattended without the device. Do not charge unit on bare carpet or
rug.
During charging process power capacity display in the screen, current is 1000mA. The battery with 0 volt
would be charged. During charging process output is available.
www.canatura.com/en
