16
NOTE
The waste connections or drain outlet shall be
designed and constructed to provide for connection to
the sanitary waste system through an air-gap of 2 pipe
diameters or 1” [25.4 mm] whichever is larger.
CAUTION
Never insert drain line directly into a drain, sewer line,
or trap. Always allow an air-gap between the drain
line and the wastewater to prevent the possibility of
sewage being back-siphoned into the softener.
Please note the
the use of inlet and
outlet arrows on
the valve to
indicate the
required water
flow direction.
3/4” Elbow
Adapters
1” Straight
Adapters
Bypass
Drain Line
Brine Line
Inlet
Outlet
INSTALLATION STEPS
TO BEGIN YOUR INSTALLATION:
1.
Make sure the bypass is attached securely to the control valve.
2.
Apply thread tape to threaded connections straight or elbow plumbing adaptors
3.
Apply the supplied lubricant (#92360) to the O-rings of the fittings.
4.
Connect the supplied straight or elbow plumbing adaptors to the bypass with red clips.
5.
Connect the inlet and outlet of the water softener to the plumbing of the house.
6.
For the drain line connection; attach a 1/2” [12.7 mm] Inside
Diameter (ID), 5/8” [15.875 mm] Outside Diameter (OD) drain
hose to the drain line fitting.
a.
Run the drain line to a floor or laundry drain.
b.
Complete any necessary plumbing to maintain a proper air gap.
NOTICE
Any solder joints near the valve must be done before
connecting any piping to the valve. Failure to do
this could cause damage to the valve.
NOTICE
Do NOT use pipe thread compound as it may attack the
material in the valve body.
NOTICE
Failure to leave enough distance could cause damage
to the valve. Always leave at least 6” [152 mm]
between the valve and joints when soldering pipes
that are connected to the valve.
Summary of Contents for 85HE
Page 2: ......
