30
31
1.
2.
3.
1.
Follow steps 1 to 3 of Powerhead Removal
above.
2.
Remove three (3) screws from the plate on
the valve body.
3.
Remove the plate from the valve body and
pull the piston assembly from the valve. The
brine valve assembly can also be removed in
this stage.
4.
If only lubricating, remove the piston
assembly, grease it with silicone lubricant
(Part #92360) and put back in.
5.
Replace seal and spacer set as shown.
Place spacer in then a seal and repeat until
finishing with a seal. Important, use the
specialized end spacer and note it’s
placement.
6.
Lubricate the piston assembly with silicone
lubricant (Part #92360) and then replace the
Piston Assembly.
Remove 3 X
Screws
Plate
Seal and
Spacer
Brine Valve
Assembly
Piston
Assembly
POWERHEAD REMOVAL
INSPECTION & REPLACEMENT OF PISTON ASSEMBLY AND SEAL & SPACER KIT
To remove the powerhead:
1.
Remove screw & washer from piston rod link.
3.
Remove powerhead from body.
2.
Remove two (2) bolts securing powerhead to
body.
NOTICE
Do NOT use petroleum-based grease products during
replacement and assembly.
SERVICING YOUR CONTROL VALVE
(CONTINUED)
Summary of Contents for 85HE
Page 2: ......
