Calibrating
the
Aimer
CHECKING CALIBRATION
OF THE LASER
Use a ruler with increments of at least 1/16"
(or 1 mm) to determine that the laser beam
height from the bottom is the same at the
laser pointer and at the front of the aimer
head, see fig. 27 and fig. 28.
REPLACING BATTERY IN LASER
To change laser batteries, remove the cap of
the laser pointer as shown in figure below.
Use three standard batteries type LR44 1.5V.
Turn the laser on and measure the height of
the beam from the bottom of the optical aimer
head, as shown.
Move the ruler to the end of the optical aimer
head to see if the height of the beam is the
same.
If there is any deviation, loosen the mounting
screws and adjust as needed.
Tighten mounting screws and repeat the
measurement to ensure that the laser has not
moved when tightening.
Extract batteries
removing this cap
fig. 27
fig. 28
CAUTION
LASER RADIATION
DO NOT STARE
INTO BEAM
CLASS II LASER PRODUCT
POWER OUTPUT < 1mW
WAVELENGHT: 630-680 nm
Calibrating the Aimer - Page 20
Canbuilt Mfg.
Perfect Night Vision.....
Summary of Contents for OPT-5405
Page 2: ......
Page 4: ......
Page 28: ......
