VADpro Menus
Pulling down anywhere on the screen will reveal the “Setup” and “DTC” buttons. The “DTC” menu allows you to
Scan and clear fault codes for the four main systems of your vehicle. ECU, Gearbox, Brake, and Haldex. Future
developments will allow you to scan and view all error codes. Pressing the “Setup” button will show the following
menu items, note, depending on your vehicle, you might see some menu items locked out.
Menu Item
Usage
Description
Popup
Toggle the switch to enable or disable
popup warnings.
Tap to cycle the minimum time period
that the popup appears from the last
trigger.
Pre-set minimum and maximum values are set for each sensor in
the DSS software. These values can also be set to your preference
with the DSS software.
The popup feature will display a big warning notice on your VADpro
for easy viewing while driving.
Logging
Toggle the switch on to begin logging
the data on the current page view.
Toggle the switch off to stop logging.
Each time you toggle the switch it will automatically save a log file
to the removable Micro SD card. Files are numbered sequentially
from 1 to 255.
Note: For quick access to start and stop logging you can also use
the shortcut button by pulling up anywhere on the screen.
Can Bus
Tap to select / reselect the TRX file for
your vehicle.
For VAD28 / VAD32 units based on UDS and TP2.0, Can Speed,
Term Filter options are locked out. These settings are for
Standalone ECU configuration.
Sensor Init
Locked menu items
Not required for editing. This is data used for future
troubleshooting if required
License
Tap to show
This is where you will find your VADpro’s serial number. Future
firmware versions will allow you to unlock additional functionality
and features.
Refresh
Locked
Refresh rate
Gears
Tap to select and use number pad for
entry
Your VADpro can display your current gear selection. On Automatic
/ DSG vehicles this setting does not need to be adjusted.
Manual vehicles need to input the RPM/Speed Ratio for each
corresponding gear in order for it to display correctly.
Splash Screen
Tap to cycle
Shows the time that the splash screen will appear after boot up.
Turning it to OFF will allow your unit to boot to your dashboard
within one second.
Start Page
Tap to cycle
Number indicates which page your unit will boot to on a power
cycle. 0 - 10 or last used.
Shift Light
Tap to cycle colors. Use the numpad to
input the RPM
For use with the external add-on Universal shift light kit.
Dim Sensitivity Tap to cycle in 10 unit increments
If you see a yellow exclamation icon, auto dim is not available. For
UDS firmware only. The higher the number, the more your VADpro
will dim in conjunction with your car’s instrument cluster. All cars
can also use the brightness slider on the lower pull up menu.
Pages
Tap to toggle
Use the widget pack submenu to view and loads widget packs.
Show or hide pages you need or don’t need from your VADpro
Custom Button
Tap to cycle
This controls the function of the lower right button of the Pull Up
menu. This currently turns the backlight of the VADpro off. In the
future other options might be added to this button.
Demo Mode
Tap to toggle
Tap to turn on or off demo mode. Demo mode is automatically
turned off after a power cycle.
Too Soon
Junior
Tap to toggle
Do you live your life a quarter mile at a time? Toggle this and mash
your gas pedal for a fun little easter egg. Once it appears it will
toggle back off
