GentleYAG Laser System
Candela Corporation
8501-00-1766 Revision F
CONFIDENTIAL
Page 45
STANDBY and READY Operating States
The system operates in one of two states: STANDBY or READY. In the STANDBY
state, laser emission is disabled. The operator must put the system into the READY
state in order to enable laser emission. In the READY state, laser pulses are generated
by depressing the trigger switch. As a safety precaution, there is a delay of two
seconds from the time that the system enters the READY state to the time that laser
emission is enabled. When the laser system is not being used, it should be returned to
the STANDBY state. The laser will automatically revert back to the STANDBY state
after 2 minutes of inactivity in the READY state. The operator selects the operating
state via the Display Panel. System state information is also displayed on the Display
Panel. When the system is in the READY state, the blue lamp to the right of the
Display Panel is illuminated.
Remote Interlock
An external connector for a remote interlock switch is provided on the back of the
system enclosure. This interlock switch can be connected to the doors of the laser
room. If the door is opened and the
GentleYAG
Laser System
is in the Ready state,
the laser system completely shuts down. For more information on installation of a
remote interlock, please call Candela Service
Note: The interlock must be in position to operate the device.
Summary of Contents for GentleYAG
