CHANNEL 5 (Zone 4) CHANNEL
6
(Zone 5)
AFTER SELECTING THE CHANNEL, NOW CHOOSE THE FEATURE:
The Feature Mode LED indicator lights work in the same way as the Channel Select LED's. When you need to select a
certain feature setting, press the GREEN (left) button. Each press of the GREEN button will increase the feature selected
by one feature number. Some LED's may be flashing, some may not. This does not matter. The Feature Mode value will
loop back to 1 after it reaches Feature 8 (all LED's OFF), and the Channel number will automatically increase by 1
Channel.
NOTE: YOU WILL ONLY BE USING FEATURE 8 - LEARN NEW DETECTOR OR REMOTE CONTROL. Refer to Learning
Detector & Learning Remote Control sections detailed later in this manual.
TO PROGRAM A NEW REMOTE CONTROL
A. Enter programming mode.
B. Select Channel 1.
C. Select Feature 8.
D. Press and hold the red button on a remote control that is already programmed into your receiver until Channel light 1
begins to flash (approx. 5 sec). As it begins to flash, immediately (within 1 sec) release the red button. Within 1 sec of
releasing the button, press the red button of the new remote control on & off 4 times in quick succession.
E. Channel 1 light will stop flashing to confirm that the remote has been successfully learnt.
F. To exit programming mode, hold down the GREEN button until the LED’s begin to scroll again (approx. 5 sec).
Note:
If you are unsuccessful with this procedure, remove power & enter programming mode again.
To Program A New Wireless PIR, Wireless Reed Switch, Or Wireless
Smoke Sensor:
FEATURE 1
4
2
1
FEATURE 2
4
2
1
FEATURE 4
4
2
1
FEATURE 3
4
2
1
FEATURE 5
4
2
1
FEATURE 6
4
2
1
FEATURE 8
4
2
1
FEATURE 7
4
2
1
When triggering or mounting any wireless device, make
sure that it is at least 5 METRES AWAY from the
receiver.
!
A. Enter programming mode.
B. Select the desired Channel (2-6).
C. Select Feature 8.
D. Press and hold the red button on a remote control that is already programmed into your receiver until the respective
Channel light(s) begin to flash (approx. 5 sec). As it begins to flash, immediately (within 1 sec) release the red button.
E. Now trigger the Detector. Notes: PIR must be in Test Mode (i.e. LED's active). For Smoke Sensor Press & Hold Test
Button on sensor until it begins to sound. Make sure detectors are at least 5m away from the receiver when triggering.
F. The respective Channel light(s) will stop flashing to confirm that the detector has been successfully learnt.
4
