Candy BCBS 1725 TK, User Manual

EN - 9

1.3 Installation warnings

Before using your fridge freezer for the first 

time, please pay attention to the following 

points:

• 

The operating voltage for your fridge 

freezer is 220-240 V at 50Hz.

•  The plug must be accessible after 

installation.

•  Your fridge freezer may have an odour 

when it is operated for the first time. This 

is normal and the odour will fade when 

your fridge freezer starts to cool. 

•  Before connecting your fridge freezer, 

ensure that the information on the data 

plate (voltage and connected load) 

matches that of the mains electricity 

supply. If in doubt, consult a qualified 

electrician.

•  Insert the plug into a socket with an 

efficient ground connection. If the socket 

has no ground contact or the plug does 

not match, we recommend you consult a 

qualified electrician for assistance.

•  The appliance must be connected 

with a properly installed fused socket. 

The power supply (AC) and voltage at 

the operating point must match with 

the details on the name plate of the 

appliance (the name plate is located on 

the inside left of the appliance).

•  We do not accept responsibility for any 

damages that occur due to ungrounded 

usage.

•  Place your fridge freezer where it will not 

be exposed to direct sunlight.

•  Your fridge freezer must never be used 

outdoors or exposed to rain.

•  Your appliance must be at least 50 cm 

away from stoves, gas ovens and heater 

cores, and at least 5 cm away from 

electrical ovens.

•  If your fridge freezer is placed next to a 

deep freezer, there must be at least 2 

cm between them to prevent humidity 

forming on the outer surface.

•  Do not cover the body or top of fridge 

freezer with lace. This will affect the 

performance of your fridge freezer.

•  Clearance of at least 150 mm is required 

at the top of your appliance. Do not place 

anything on top of your appliance.

•  Do not place heavy items on the 

appliance.

•  Clean the appliance thoroughly before 

use (see Cleaning and Maintenance).

•  Before using your fridge freezer, wipe all 

parts with a solution of warm water and 

a teaspoon of sodium bicarbonate. Then, 

rinse with clean water and dry. Return all 

parts to the fridge freezer after cleaning.

•  The installation procedure into a kitchen 

unit is given in the installation manual. 

This product is intended to be used in 

proper kitchen units only.

•  Install the two plastic distance guides (the 

parts on the black vanes 

-condenser- at the rear) 

by turning it 90° (as 

shown in the figure) to 

prevent the condenser 

from touching the wall.

•  The distance between 

the appliance and back wall must be a 

maximum of 75 mm.