EN
81
2. WATER CONNECTION
l
The inlet and drain hoses can be directed
to left or right.
l
Water pressure must be between 0,08
MPa and 0,8 MPa.
l
The inlet hose must be connected to a tap
so that the water supply can be cut off
when the machine is not in use
(fig. 1 B).
l
The dishwasher is fitted with 3/4" threaded
connector
(fig. 2)
.
l
Connect inlet hose
"A"
to water tap
"B"
with a 3/4" attachment making sure that it
has been properly tightened.
l
If it is necessary, the inlet pipe can be
lengthened up to 2,5 m. The extension
pipe is available from the After Sales
Service Centre.
l
If the dishwasher is connected to new pipes
or to pipes which have not been inuse for a
long time run water through for a few
minutes before connecting the inlet hose. In
this way no deposits of sand or rust will
clog up the water inflow filter.
1
B
2
B
A
The appliance must be connected to
the water mains using new hose-sets.
The old hose-sets should not be
reused.
The dishwasher can be connected to
either cold or hot water, as long as it
is no hotter than 60°C.
