Candy CBT6240W, User Instructions

 GENERAL

Carefully read the following important information regarding 

installation safety and maintenance. Keep this information 

booklet accessible for further consultations. The appliance 

has been designed for use in the ducting version (air exhaust 

to the outside - Fig.3A), filtering version (air circulation on the 

inside - Fig.3B) or with external motor (Fig.3C).

  SAFETY PRECAUTION

1. 

Take care when the cooker hood is operating simultane-

ously with an open fireplace or burner that depend on the air 

in the environment and are supplied by other than electrical 

energy, as the cooker hood removes the air from the environ-

ment which a burner or fireplace need for combustion. The 

negative pressure in the environment must not exceed 4Pa 

(4x10-5 bar). Provide adequate ventilation in the environment 

for a safe operation of the cooker hood.

Follow the local laws applicable for external air evacuation.

Before connecting the model to the electricity network:

- Control the data plate (positioned inside the appliance) 

to ascertain that the voltage and power correspond to the 

network and the socket is suitable. If in doubt ask a qualified 

electrician.

- If the power supply cable is damaged, it must be replaced 

with another cable or a special assembly, which may be 

obtained direct from the manufacturer or from the Technical 

Assistance Centre.

- This device must be connected to the supply network 

through either a plug fused 3A or hardwired to a 2 fase spur 

protected by 3A fuse.

2. Warning!

In certain circumstances electrical appliances may be a 

danger hazard.

A) Do not check the status of the filters while the cooker 

hood is operating.

B) Do not touch bulbs or adjacent areas, during or straight 

after prolonged use of the lighting installation.

C) Flambè cooking is prohibited underneath the cooker 

hood.

D) Avoid free flame, as it is damaging for the filters and a 

fire hazard.

E) Constantly check food frying to avoid that the over-

heated oil may become a fire hazard.

F) Disconnect the electrical plug prior to any maintenance.

G) This appliance is not intended for use by young children 

or infirm persons without supervision.

H) Young children should be supervised to ensure they do 

not play with the appliance

I)  There shall be adequate ventilation of the room when 

the rangehood is used at the same time as appliances 

burning gas or other fuels.

L)  There is a risk of fire if cleaning is not carried out in 

accordance with the instructions.

This appliance conforms to the European Directive EC/2002/96, 

Waste Electrical and Electronic Equipment (WEEE). By making 

sure that this appliance is disposed of in a suitable manner, the 

user is helping to prevent potential damage to the environ-

ment or to public health.

The symbol on the product or on the accompanying 

paperwork indicates that the appliance should not be 

treated as domestic waste, but should be delivered to 

a suitable electric and electronic appliance recycling collection 

point. Follow local guidelines when disposing of waste. For 

more information on the treatment, re-use and recycling of 

this product, please contact your local authority, domestic 

waste collection service or the shop where the appliance was 

purchased.

  INSTALLATION INSTRUCTIONS

•  Assembly and electrical connections must be carried out 

by specialised personnel.

•  Wear  protective  gloves  before  proceeding  with  the 

installation.

•  Electric Connection:

- The appliance has been manufactured as a class II, therefore 

no earth cable is necessary. The plug must be easily acces-

sible after the installation of the appliance. If the appliance 

is equipped with power cord without plug, a suitably di-

mensioned omnipolar switch with 3 mm minimum opening 

between contacts must be fitted between the appliance and 

the electricity supply in compliance with the load and current 

regulations.

- The connection to the mains is carried out as follows:

BROWN = 

L

 line

BLUE = 

N

 neutral.

•  

The minimum distance between the support surfaces of 

the cooking pots on the cooker top and the lowest part of 

the cooker hood must be at least 

65 cm

. If a connection 

tube composed of two parts is used, the upper part must be 

placed outside the lower part. Do not connect the cooker 

hood exhaust to the same conductor used to circulate hot air 

or for evacuating fumes from other appliances generated by 

other than an electrical source. Before proceeding with the 

assembly operations, remove the anti-grease filter(s) (Fig.4) 

so that the unit is easier to handle.

- In the case of assembly of the appliance in the suction version 

prepare the hole for evacuation of the air.

•  

We recommend the use of an air exhaust tube which has the 

same diameter as the air exhaust outlet hole. If a pipe with 

a smaller diameter is used, the efficiency of the product may 

be reduced and its operation may become noisier.

•  

If your appliance has been designed for use in habitations 

supplied with acentralised suction device perform the follow-

ing operations:

- The switch controls opening and closure of a valve using 

a thermoelectical device. By placing the switch in the 

ON 

position, after a minute, the valve opens rotating 90° allow-

ing suction of the stale air. By placing the switch in the

 OFF

position, the valve closes after 100 seconds.

•  Installation:

The following instruction should be followed to carry out the 

correct installation of the cooker hood.

1. Mounting of the cooker hood on the lower side of the 

cupboard.

2. Selection of the version (extraction Fig.3A or filtration 

Fig.3B).

ENGLISH

GB

- 22 -