ENGLISH
11
Trouble shooting
Should your dryer operate incorrectly,
check the following points before calling
for a service engineer.
Drying time is too long/clothes are not
dry enough:
●
Have you selected the correct drying
time/program? Go to page 7.
●
Were the clothes too wet? Were the
clothes thoroughly wrung or spin-
dried?
●
Does the filter need cleaning? Go to
page 6.
●
Is the dryer overloaded? Go to page 5.
●
Is the venting hose kinked or blocked?
Go to page 4.
●
Is the load too small? Go to page 9.
●
Has the ‘DELICATES’ option been
selected from a previous cycle? Go to
page 8.
The dryer does not operate:
●
Is there a working electricity supply to
the dryer? Check using another
appliance such as a table lamp.
●
Is the plug properly connected to the
mains supply?
●
Is there a power failure?
●
Has the fuse blown?
●
Is the door fully closed? Go to
page 9.
●
Is the dryer switched on, both at the
mains supply and at the machine? Go to
page 8.
●
Has the drying time or the program
been selected? Go to page 8.
●
Has the ‘ON’ button been pressed after
opening the door? Go to page 6.
Filter Care Indicator on
●
Does the filter need cleaning? Go to
page 6.
●
Is the venting hose kinked or blocked?
Go to page 4.
If the supply cord on this appliance is
damaged, it must be replaced by a special
cord which is only available from GIAS
Service or an authorised GIAS Dealer.
Should there still be a problem with your
dryer after completing all the
recommended checks, please call GIAS
Service for advice. They may be able to
assist you over the telephone or arrange for
a suitable appointment for an engineer to
call under the terms of your guarantee.
However, a charge may be made if any of
the following applies to your machine:
●
Is found to be in working order.
●
Has not been installed in accordance
with the installation instructions.
●
Has been used incorrectly.
