3 GB
NEW COMBINED SINGLE COMPRESSOR FRIDGE FREEZERS
CONTROL PANEL
Open the top door of the fridge in order to access the control panel.
Turn the Dial to switch on the appliance, then set the temperature of the freezer compartment (recommended setting - 2 or 3) and fridge. Turn the
dial to „0“ or „
z
“ to turn the appliance off. To completely remove the voltage from the appliance, disconnect the plug from the power output.
FREEZING
(Figure 1)
The preservation of frozen foods is guaranteed in all of the freezer’s compartments.
During maximum capacity of the freezer, it is advised to remove the drawers and to place the food directly on the shelves for optimal freezing.
In some products there is a
section at the top (see quick guide).
Place the foods to be frozen in the
drawer, turn the thermostat clock-wise to position 5. After 24 hours, freezing is completed. Therefore,
reset the thermostat to position 2-3
The rating plate states the maximum quantity of foods that can be frozen, (see figure 2)
To test the freezing and conservation functions, remove all the drawers apart from the bottom one.
DEFROSTING
(Figure 2)
Defrosting of the fridge compartment is automatic in this
product.
A small amount of frost/drops of water on the back of the fridge
compartment is normal when the freezer is on.
Make sure the water outlet is always clean. Ensure foods do
not touch the back or sides of the fridge compartment.
We recommend you defrost the freezer area when the layer of
frost is more than 3 mm thick.
NB. This is the rating plate. If you need to contact our Service Department in the event of faults, remember to give them the information
on the plate.
Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost will deposit
on the back of the fridge compartment. In this case, turn the dial to a lower settings (1-2).
