11
BULB REPLACEMENT
Important :
The bulb must be replaced by the manufacturer, its
service agent or similarly qualified persons.
Always switch off the electricity supply before
carrying out any operations on the appliance. When
handling bulb, make sure it has completely cooled
down before any direct contact with hands.
When handling bulbs hold with a cloth or gloves to
ensure perspiration does not come in contact with
the bulb as this can reduce the life of the bulb.
Note:
Before changing the lights, make sure that the appliance is turned off and
unplugged.
Protect against danger when changing lights, such as wearing gloves.
Changing the lights:
• Remove the grease filter.
• Loosen the 2pcs ST4*8mm screws from the lighting panel, then take out the
lighting fixture.
• Disassembly the 3pcs ST3*12mm screws on the terminal box cover and take down
the wire cover.
• Pull out the terminal from the PCB terminal block, disconnect the wire connector
and replace the lamp.
•
ILCOS D code for this lamp is: DBS-2/65-H-120/33
– LED modules –rectangle lamp
– Max wattage: 1
×
2 W
– Voltage range: AC 110-240V
– Dimensions:
