11
NOTE:
Make sure the filter is securely locked. Otherwise, it would loosen and cause
danger.
When activated carbon filter attached, the suction power will be lowered.
BULB REPLACEMENT
Important :
The bulb must be replaced by the manufacturer, its
service agent or similarly qualified persons.
Always switch off the electricity supply before
carrying out any operations on the appliance. When
handling bulb, make sure it has completely cooled
down before any direct contact to hands.
When handling blubs hold with a cloth or gloves to
ensure perspiration does not come in contact with
the blub as this can reduce the life of the blub.
Note:
Before changing the lights
that the cooker hood can be isolated from the supply
mains by means of a plug or an all-pole switch.
Protect against danger when changing lights, such as wearing gloves.
Changing the light
• Remove the grease filter.
• Loosen the 2pcs ST4*8mm screws from the lighting panel, then take out the
lighting fixture.
• Disassembly the 3pcs ST3*12mm screws on the terminal box cover and take down
the wire cover.
• Pull out the terminal from the PCB terminal block, disconnect the wire connector
and replace the lamp.
•
ILCOS D code for this lamp is: DBS-2/65-H-120/33
– LED modules –rectangle lamp
– Max wattage: 1
×
2 W
– Voltage range: AC 110-240V
– Dimensions:
