20
CLEANING AND MAINTENANCE
Cleaning before use
Before use, you should clean the Fridge/Freezer internally with a weak solution of bicarbonate of
soda. Then rinse with warm water using a damp sponge or cloth and wipe dry. Wash the baskets in
warm soapy water and ensure they are completely dry before replacing in the Fridge/Freezer.
Clean the exterior of the unit with a damp cloth.
Defrosting
This is a total no-frost refrigerator, defrost is performed automatically. There is no need to defrost
the freezer manually
Cleaning the Interior and the Exterior of the Unit
Dusts behind the refrigerator and on the ground shall be timely cleaned to improve the
cooling effect and energy saving.
Check the door gasket regularly to make sure there are no debris. Clean the door gasket
with a soft cloth dampened with soapy water or diluted detergent.
The interior of the refrigerator should be cleaned regularly to avoid odor.
Before cleaning, turn off the appliance and remove all food, drinks ,shelves, drawers,
etc.
Use a soft cloth or sponge to clean the inside of the refrigerator, with two tablespoons
of baking soda and a quart of warm water. Then rinse with water and wipe clean. After
cleaning, open the door and let it dry naturally before turning on the power.
It is recommended to wipe areas that are difficult to clean regularly with a soft rag, soft
brush, etc. and when necessary, combined with some auxiliary tools (such as thin sticks)
to ensure no contaminants or bacterial accumulation in these areas.
Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause
odors in the interior of the refrigerator or contaminated food.
Clean bottle frame, shelves and drawers, as well as the surface of the appliance with a
soft cloth dampened with soapy water or diluted detergent. Dry with a soft cloth or dry
naturally.
Do not use hard brushes, clean steel balls, wire brushes, abrasives, organic solvents
(such as alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline items, which
may damage the fridge surface and interior. Boiling water and organic solvents such as
benzene may deform or damage plastic parts.
Do not rinse directly with water or other liquids during cleaning to avoid short circuits
or affect electrical insulation after immersion.
Condensation may appear on the outside of the unit. This may be due to a change in
room temperature. Wipe of any moisture residue. If the problem continues, please
contact a qualified technician for assistance.
Moving the appliance
1.
Remove all food and unplug the appliance
2.
Secure shelves and other moveable parts in the fridge and in the freezer with adhesive tape
3.
Do not tilt the refrigerator more than 45° to avoid damaging the refrigerating system
