37
INSTALLATION INSTRUCTIONS
1.
If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will
cause the compressor to run for long periods. If installed next to a source of heat or
refrigerator, maintain the following minimum side clearances:
From Cookers
4" (100 mm)
From Radiators
12" (300 mm)
From Fridges
4" (100 mm)
2.
Make sure that sufficient room, with an average temperature of between 16°C and 32°C, is
provided around the appliance to ensure free air circulation. Ideally, a space of no less than
9cm on the back and 2cm on the sides.
3.
The appliance should be located on a smooth surface.
4.
It is forbidden to use the refrigerator outdoors.
5.
Protection from moisture. Do not locate the freezer in moist space to avoid the metal parts
rusty. And do not spray water to the freezer, otherwise it will weaken the insulation and
causes current leakage.
6.
Refer to "Cleaning and Care" section to prepare your appliance for use.
7.
If the freezer is installed in unheated areas, garages etc., in cold weather condensation may
form on the outer surfaces. This is quite normal and is not a fault. Remove the condensation
by wiping with a dry cloth.
8.
Never place Refrigerator in a wall recessed or into fitted cabinets or fumiture when it is
working, the grille at the back may become hot and the sides warm. Do not drape the
Refrigerator with any covering.
STARTING TO USE
Before you starting to use the freezer, please check that:
1.
The interior is dry and air can circulate freely at the rear.
2.
Clean the interior as recommended under "TAKE CARE" section (electric parts of the
refrigerator can only be wiped by dry cloth).
3.
Do not switch on until 4 hours after moving the fridge/freezer. The coolant fluid needs
time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
4.
Before connecting the Refrigerator to the mains supply position. The thermostat control
dias is located inside the Fridge compartment.
5.
Turn the thermostat knob to the “3” position and turn on the electricity. The compressor
and the light inside the refrigerator will begin to work.
6.
Before storing foods in your refrigerator, turn the refrigerator on and wait for 24 hours,
to make sure it is working properly and to allow the Fridge/Freezer to fail to the correct
temperature.
7.
Open the door 30 minutes later, if the temperature in the refrigerator decreased
obviously, it shows that the refrigerator system works well. When the refrigerator
operates for a period of time, the temperature controller will automatically set the
temperature within limits it opens.
Summary of Contents for COMBI
Page 1: ...USER MANUAL COMBI ...
Page 563: ...563 ...
Page 564: ...CANDY HOOVER GROUP S R L Via Privata Eden Fumagalli 20861 Brugherio Milan Italy ...
