Candy CPLA335K, Manual

5 GB

A

Place the appliance on the floor or at a 45° angle, 
as it is necessary to work on the bottom of the 
appliance. 

Take off the bottom right-hand hinge by removing 
the screws, pin and washers, then remove the 
lower door.

Mark and break the left-hand slot on the panel, in 
the insert area.

Flip the top left-hand hinge found in the 
accessories kit.

Fit the panel, and secure with the screws and 
caps.

To reverse the handles: remove the outer caps 
from the right-hand side of the doors.

Remount the hinges and doors working from 
bottom to top, 

Unscrew the handles from the left-hand side and 
move them to the right-hand side, then position 
the outer caps on the left-hand side of the doors.

Remove the lower plinth by pulling out the 3 
protective plugs and by loosening the screws.

Remove the caps (A) and (B), loosen the screws 
and partially remove the panel.

Unscrew the right hinge.

Drill the plinth on the marked left hand-side area.

REVERSING THE OPENING OF THE DOORS 

In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.

Place the appliance on the floor or at a 45° angle, 
as it is necessary to work on the bottom of the 
appliance. 

Mark and break the left-hand slot on the panel, in 
the insert area.

With another panel type, break the plastic 
membrane and screw the hinge on the left-hand 
side of the panel.

Screw the panel back on and place the outer 
label back on. Put the  appliance in the upright 
position and wait two hours before turning it on.

To reverse the handles: remove the outer caps 
from the right-hand  side of the doors.

Unscrew the handles from the left-hand side and
remount them on the right-hand side of the product.
Place the plugs on the left-hand side.

Insert the pin in the hinge and the spacer in the 
insert. Reassemble the hinges and doors 
working from bottom to top.

Remove the plug on the left-hand side and insert 
it on the right-hand side of the central and lower 
inserts. Invert the bushing in the lower insert.

With this panel type, remove the label and screws, 
then partially remove the panel.

Remove the screws from the top right hinge and 
invert the position of the pin, then reassemble it on 
the left-hand side.

Take off the bottom right-hand hinge by removing 
the screws, pin and washers, then remove the 
lower door.

Remove the lower plinth by pulling out the 
3 protective plugs and by loosening the screws. 

Mark and break the plinth on the marked left 
hand-side area.

1) break the 
plastic membrane

2) Insert the pin

spacer

bushing

plug

Put the appliance in an upright position and wait two hours before turning it on.

B

Put the appliance in an upright position and wait two hours before turning it on.