73
EN
Rotating the programme selector in both
directions it's possible to select the
desired drying programme.
To cancel the selections or switch off the
appliance rotate the programme selector
on
OFF
(remember to unplug the appliance).
To start the selected cycle with the preset
parameters, press
START/PAUSE
. When
the programme is running, the display will
show the time to elapse.
Moreover, if you want to modify the
chosen programme, press the desired
options buttons, modify the default
parameters and then press
START/
PAUSE
button to start the cycle.
After switching on the appliance, wait a few
seconds for the programme to start running.
PROGRAMME DURATION
When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
Once the programme has started you will
be kept informed constantly of the time
remaining to the end of the drying cycle.
The appliance calculates the time to the
end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to the
humidity level of the load.
PROGRAMME END
"END"
(
"End"
on
some models) will
appear in the display at the end of the
programme, it is now possible to open the
door.
At the end of the cycle, turn off the
appliance by turning the programme
selector to the
OFF
position.
PAUSING THE MACHINE
Keep the
START/PAUSE
button pressed
for about
2
seconds
(the residual time
display will flash, showing that the
machine is paused).
Press the
START/PAUSE
button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
To cancel the programme, turn the
programme selector to the
OFF
position.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, by pressing the
START/PAUSE button, the machine will
restart from the beginning of the phase it
was in when the power was lost.
The programme selector must
ALWAYS be put in the OFF position at
the end of the drying cycle before a
new one can be selected.
Only the options compatible with the
set programme can be selected.
Close the porthole BEFORE pressing
the START/PAUSE button.
START/PAUSE button
PROGRAMME SELECTOR with
OFF position
WARNING
Don’t touch the buttons while inserting
the plug because the machines
calibrates the systems during the first
seconds: touching the buttons, the
machine couldn’t work property. In
this case, remove the plug and repeat
the operation.
Summary of Contents for CRE H10A2DE-S
