7
9.
Should the lining up of the
furniture door be necessary , use the
clearance of slots .At the end of
operations, it is necessary to check
the door of the furniture closes
properly.
10.
Fix cover (D) on guide (B) until it
clips into place.
Reversing the door
The side at which the door opens can be changed from the right side(as
supplied) to the left side, if the installation site requires.
Warning!
When changing the side at which the door opens, the appliance must not be
connected to the mains. Remove plug from the mains beforehand.
The side at which the door opens can be changed from the right side (as supplied) to
the left side, if the installation site requires. Tilt the
appliance slightly towards the rear and prop it
securely. Unscrew the door hinge screws and
remove the hinge pin bracket. Open the door a little
way and take it out downwards.
Unscrew the upper pin and screw it into place on
the opposite side. Fit the door into the upper pin and
close it. Screw the hinge pin bracket securely into
place on the opposite side using the screws.
Summary of Contents for CRU 160 E
