EN
50
Temperature indicator
In order to help you better set your refrigerator, we have
equipped it with a temperature indicator located in the coldest
area.
To better store the food in your refrigerator, especially in the
coldest area, make sure the message “OK” appears on the
temperature indicator. If « OK » does not appear, this means
temperature has not been set properly
It may be difficult to see the indicator, make sure it is properly
lit.Each time the temperature setting device is changed, wait
for the stabilisation of the temperature inside the appliance
before proceeding, if necessary, with a new temperature
setting. Please change the position of the temperature
setting device progressively and wait at least 12 hours before
starting a new check and potential change.
NOTE:
Following repeated openings (or prolonged opening)
of the door or after putting fresh food into the appliance,
it is normal for the indication “OK” not to appear in the
temperature setting indicator. If there is an abnormal build up
of ice crystals of ice crystals (bottom wall of the appliance)
on the refrigerator compartment, evaporator (overloaded
appliance, high room temperature, frequent door openings),
put the temperature setting device on a lower position until
compressor off periods are obtained again.
Store food in the coldest area of the refrigerator.
Your foods will be better stored if you put them in
the most appropriate cooling area. The coldest
area is just above the crisper.
The following symbol indicates the coldest area
of your refrigerator.
To be sure to have a low temperature in this area, make sure
the shelf is located at the level of this symbol, as shown in
the illustration.
The upper limit of the coldest area is indicated by the lower
side of the sticker (head of the arrow). The coldest area
upper shelf must be at the same level with the arrow head.
The coldest area is below this level.
As these shelves are removable, make sure they are always
OK
THE VARIOUS FUNCTION AND POSSIBILITIES
