12
12
FASTENING THE COOKTOP
Each cooktop is provided with an installation
kit including brackets and screws for
fastening the cooktop to benches from 30
to 40mm thick.
30 and 60cm wide models (fig. 1.2a,
1.2b):
The kit includes two “
F
” type brackets
(for the front of the cooktop), two “
R
” type
brackets (for the rear of the cooktop) and
four self-threading screws “
S
”.
90cm wide models (fig. 1.2c):
The kit
includes four “
F
” type brackets (for the front
of the cooktop), three “
R
” type brackets (for
the rear of the cooktop) and seven self-
threading screws “
S
”.
•
Cut the unit according to the
dimensions in fig. 1.1a.
•
Stretch gasket “
G
” over the edge of the
hole made, being careful to overlay the
junction edges (figs. 1.2d, 1.2e).
•
Fasten the brackets “
F
” and “
R
” to
the appropriate socket holes, without
tightening the screws “
S
” for the
moment. Make sure that the tabs are
mounted correctly, as shown (figs.
1.2h, 1.2i). Rotate the tabs so that the
cooktop can be put into the cutout.
For the 60 and 90cm wide models,
stretch the gasket "
G2
" along the entire
perimeter of the cooktop. (figs. 1.2f,
1.2g).
•
Put the cooktop into the cutout and
position it correctly.
•
Put the brackets “
F
” and “
R
” into place;
tooth “
A
” of the brackets should go into
the hole (figs. 1.2h, 1.2i).
•
Tighten screws “
S
” until the cooktop is
completely secured to the bench.
•
Using a sharp cutter or trimmer knife,
trim the excess sealing material
around the edge of the cooktop.
Take care not to damage the
workbench.
F
F
F
F
R
R
R
F
F
R
R
F
F
F
F
R
R
R
F
F
R
R
Fig. 1.2b
Fig. 1.2c
G
G1
G2
Fig. 1.2e
Fig. 1.2d
R
F
R
F
Fig. 1.2a
G
