EN - 13 -
without interruption after being plugged in to be completely cooled. Do not open doors
of your fridge frequently and do not place much food inside it in this period.
• During power cut, to prevent any compressor problem you should unplug the refrigerator.
You should delay pluging in 5 – 10 minutes after your power supply returns. If you plug
out the refrigerator for a reason you should wait at least 5 min to replug. It is important
for avoiding damage to refrigerator’s components.
• Your fridge is designed to operate in the ambient temperature intervals stated in the
standards, according to the climate class stated
in the information label. We do not recommend
operating your fridge out of stated temperatures
value limits in terms of cooling effectiveness.
•
This appliance is designed for use at an
ambient temperature within the 10°C - 43°C
range.
Climate class
Ambient (
o
C)
T
16 to 43 (
o
C)
ST
16 to 38 (
o
C)
N
16 to 32 (
o
C)
SN
10 to 32 (
o
C)
Temperature indicator
In order to help you better set your refrigerator, we have equipped it with
a temperature indicator located in the coldest area.
To better store the food in your refrigerator, especially in the coldest area,
make sure the message “OK” appears on the temperature indicator. If
« OK » does not appear, this means that the temperature setting has
not been done properly.
Since “OK” appears in black, it will be difficult to see this indication if the
temperature indicator is badly lit. To be able to see this indication properly, there
should be enough light.
Each time the temperature setting device is changed, wait for the stabilisation
of the temperature inside the appliance before proceeding, if necessary, with a
new temperature setting. Please change the position of the temperature setting
device progressively and wait at least 12 hours before starting a new check and
potential change.
NOTE:
Following repeated openings (or prolonged opening) of the door or
after putting fresh food into the appliance, it is normal for the indication “OK”
not to appear in the temperature setting indicator. If there is an abnormal ice
crystals build up (bottom wall of the appliance) on the refrigerator
compartment evaporator (overloaded appliance, high room
temperature, frequent door openings), put the temperature setting
device on a lower position until compressor off periods are obtained
again.
Putting food in the coldest area of the refrigerator
Your foods will be better stored if you put them in the most appropriate cooling
area. The coldest area is just above the crisper.
The following symbol indicates the coldest area of your refrigerator.
To be sure to have a low temperature in this area, make sure the shelf is located
at the level of this symbol, as shown in the illustration.
OK
Summary of Contents for CVS 6184X
Page 183: ...52284106 ...
