14
Important!
Ethereal oils and organic solvents can
attack plastic parts, e.g. lemon juice or the juice
form orange peel, butyric acid, cleanser that
contain acetic acid.
•
Do not allow such substances to come into
contact the appliance parts.
•
Do not use any abrasive cleaners
•
Remove the food from the freezer. Store them
in a cool place, well covered.
•
Switch the appliance off and remove the plug
from the mains, or switch off or turn out the
circuit breaker of fuse
•
Clean the appliance and the interior accessories
with a cloth and lukewarm water. After cleaning
wipe with fresh water and rub dry.
•
After everything is dry place appliance back into
service.
Troubleshooting
Caution!
Before troubleshooting,
disconnect the power supply. Only a
qualified electrician of competent
person must do the troubleshooting
that is not in this manual.
Important!
There are some sounds during normal
use (compressor, refrigerant circulation).
If the malfunction shows again, contact the
Service Center
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to
the rating plate.
Problem
Possible cause
Solution
Appliance
dos not work
Mains plug is not
plugged in or is
loose
Insert mains plug.
Fuse has blown or
is defective
Check fuse, replace
if necessary.
Socket is defective
Mains malfunctions
are to be corrected
by an electrician.
Appliance
freezes or
cools loo
much
Temperature is set
too cold or the
appliance runs at
SUPER modes,
Turn the
temperature
regulator to a
warmer setting
temporarily.
The food is
not frozen
enough.
Temperature is not
properly adjusted.
Please look in the
initial Temperature
Setting section.
Door was open for
an extended
period.
Open the door only
as long as
necessary.
Problem
Possible cause
Solution
A large quantity of
warm food was
placed in the
appliance within
the last 24 hours.
Turn the
temperature
regulation to a
colder setting
temporarily.
The appliance is
near a heat source.
Please look in the
installation
location section.
Heavy build
up of frost
on the door
seal.
Door seal is not air
light.
Carefully warm the
leaking sections of
the door seal with
a hair dryer (on a
cool setting) At the
same time shape
the warmed door
seal by hand such
that it sits
correctly.
Unusual
noises
Appliance is not
level.
Re-adjust the feet.
The appliance is
touching the wall
or other objects.
Move the
appliance slightly.
A component, e.g.
a pipe on the rear
of the appliance is
touching another
part of the
appliance or the
wall.
If necessary,
carefully bend the
component out of
the way
Side panels
are hot
It’s normal. Heat
exchange is in the
side panels.
Take gloves to
touch side panels if
need.
If the malfunction shows again, contact the
Service Center.
These data are necessary to help you quickly and
correctly. Write the necessary data here, refer to
the rating plate.
