• Connect a plug to the supply cable that is able to bear the voltage,
current and load indicated on the tag and having the earth contact. The
socket must be suitable for the load indicated on the tag and must be
having the earth contact connected and in operation. The earth conductor
is yellow-green in colour. This operation should be carried out by a suitably
qualified professional. In case of incompatibility between the socket and
the appliance plug, ask a qualified electrician to substitute the socket with
another suitable type. The plug and the socket must be conformed to the
current norms of the installation country. Connection to the power source
can also be made by placing an omnipolar breaker between the appliance
and the power source that can bear the maximum connected load and
that is in line with current legislation. The yellow-green earth cable should
not be interrupted by the breaker. The socket or omnipolar breaker used
for the connection should be easily accessible when the appliance is
installed.
•The disconnection may be achieved by having the plug accessible or by
incorporating a switch in the fixed wiring in accordance with the wiring
rules.
•If the power cable is damaged, it must be substituted with a cable or
special bundle available from the manufacturer or by contacting the
customer service department.
•The type of power cable must be H05V2V2-F.
•Failure to comply with the above can compromise the safety of the
appliance and invalidate the guarantee.
•Any excess of spilled material should be removed before cleaning.
•During the pyrolytic cleaning process, surfaces can heat up more than
usual, children must therefore be kept at a safe distance.
•The appliance must not be installed behind a decorative door in order to
avoid overheating.
•When you place the shelf inside, make sure that the stop is directed
upwards and in the back of the cavity.
The shelf must be inserted completely into the cavity
• WARNING: Do not line the oven walls with aluminum foil or single-use
protection available from stores. Aluminum foil or any other protection, in
direct contact with the hot enamel, risk melting and deteriorating the
enamel of the insides.
• WARNING: Never remove the oven door seal.
• No additional operation/setting is required in order to operate the
appliance at the rated frequencies
EN 17
