TROUBLESHOOTING
What Might be the Cause of...
Defects you can remedy yourself
Before calling GIAS Service for technical
advice please run through the following
checklist. A charge will be made if the machine
is found to be working or has been installed
incorrectly or used incorrectly.
If the problem persists after completing the
recommended checks, please call GIAS
Service, they may be able to assist you over
the telephone.
Drying time is too long/clothes are not dry
enough…
●
Have you selected the correct drying
time/programme?
●
Were the clothes too wet? Were the clothes
thoroughly wrung or spindried?
●
Does the filter need cleaning?
●
Is the dryer overloaded?
●
Is the venting hose kinked or blocked?
●
Has the
option been selected from a
previous cycle?
The dryer does not operate…
●
Is there a working electricity supply to the
dryer? Check using another
appliance such as
a table lamp.
●
Is the plug properly connected to the mains
supply?
●
Is there a power failure?
●
Has the fuse blown?
●
Is the door fully closed?
●
Is the dryer switched on, both at the mains
supply and at the machine?
●
Has the drying time or the programme been
selected?
●
Has the machine been switched on again
after opening the door?
The dryer is noisy…
●
Switch off the dryer and contact GIAS
Service for advice.
The Indicator is on…
●
Does the filter need cleaning?
●
Is the venting hose kinked or blocked?
CUSTOMER SERVICE
Should there still be a problem with your dryer
after completing all the recommended checks,
please call GIAS Service for advice.
They may be able to assist you over the
telephone or arrange for a suitable appointment
for an engineer to call under the terms of your
guarantee. However, a charge may be made if
any of the following applies to your machine:
●
Is
found
to
be
in
working
order
.
●
Has
not
been
installed
in
accordance
with
the
installation instructions.
●
Has
been
used
incorrectly
.
EN 14
Spares
GIAS Service
Always use genuine spares, available direct
from
GIAS Service.
For service and repairs call your local GIAS
Service
engineer.
The manufacturer declines all responsibility
in the
event of any printing mistakes in this
booklet. The
manufacturer also reserves the
right to make
appropriate modifications to
its products without
changing the essential
characteristics.
