45
REGULATING THE RINSE AID (from 1 to 6).
The regulator control "B" is below the indicator and can be turned with the finger, the
recommended position is "3".
The hardness of the water can be judged by incrustation or by the level of dryness.
It is therefore important that the correct dosage of Rinse Aid is regulated to give the best
results.
After the wash,
. if streaks occur on the dishes, decrease the amount by one position.
. if whitish spots occur, increase the amount by one position.
LOADING THE SALT
The dishwasher is fitted with a softener that clears the water of lime which could cause scale
and damage the dishwasher.
On the bottom of the diswasher there is a salt dispenser for regenerating the softener.
The filter element of the softener unit should be recharged with a salt specially produced for
dishwashers. This salt can be bought either as tablets or as granules.
To add salt, unscrew the cap of the salt dispenser on
the bottom and refill the dispenser.
During this operation a little water will overflow but keep
adding salt until the dispenser is fill, clean the thread of
salt residue and retighten the cap.
If the dishwasher is not required straightaway, set
the programme Cold rinse ("Eco+Rapid, 2 Leds")
so that the salt solution which has overflowed is
discharged from the washing tank.
The salt dispenser has a capacity of between 1.5 kg for
efficient use of the appliance, it should be refilled from
time to time according to the regulation of the water
softener unit.
NB: it is necessary to add water until the dispenser overflows. Only install the dishwasher
completely filling the salt dispenser.
