Enter 98 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-2-1-10.
Set Time Delay for a Digit for SPP
This parameter refers to the amount of elapsed time to delay transmitting a digit. Please
follow the below steps to set time-delay variable for a digit for SPP if the associated
operations are performed using the RS-232 or USB COM interfaces.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
StdSppTxCharGapTime
barcode to configure delay time for a digit for
SPP.
(3)
Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal value
barcodes representing the desired value in the range of 0 to 255. For instance, to
defer transmitting a digit for 0.2 seconds, scan
2, 0,
and then
0
to assign the
specified decimal value “200”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*AAAE0*
StdSppTxCharGapTime
AAAE0
(Length: 1 digit / Range: 0-255/ Unit: 1ms)
