Enter 99 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-2-1-11.
Set Time Delay for a Record for SPP
This parameter refers to the amount of elapsed time to delay transmitting a record. Please
follow the below steps to set time-delay variable for a record for SPP if the associated
operations are performed using RS-232 or USB COM interfaces.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
StdSppTxGapTime
barcode to configure delay time for a record for SPP.
(3)
Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal value
barcodes representing the desired value in the range of 0 to 255. For instance, to
defer transmitting a record for 0.2 seconds, scan
2
first and then
0
to assign the
specified decimal value “20”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*AABE0*
StdSppTxGapTime
AABE0
(Length: 1 digit / Range: 0-255/ Unit: 10ms)
