Enter 119 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-2-2-17.
Set Hibernation Duration
While remaining inactive for a period of time, the device will be forced to enter
power-saving mode for considerations to lower power consumption. As a result, this
parameter is available to specify the amount of time allocated for the device to stay in
hibernation. Once the specified time period expires, the scanner will be shut down
immediately. Please follow the below steps to configure hibernation duration.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
BarHibernateTime
barcode to configure hibernation duration.
(3)
Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal value
barcodes representing the desired value in the range of 0 to 255. For instance, to
set hibernation duration to be 10 seconds, scan
1
first and then
0
to assign the
specified decimal value “10”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*B39E0*
BarHibernateTime
B39E0
(Length: 1 digit / Range: 0-255/ Unit: 1000ms)
