Enter 121 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-2-2-19.
Set Idle Duration
The device will switch to power-saving mode after remaining idle for a while. This
parameter is thus used to specify the length of time allocated for the scanner to elapse
before power-saving mode is initiated.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
BarIdleTime
barcode to configure idle duration.
(3)
Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal value
barcodes representing the desired value in the range of 0 to 255. For instance, to
set idle duration to be 3 seconds, the scan
3
to assign the specified decimal value
“3”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*B3BE0*
BarIdleTime
B3BE0
(Length: 1 digit / Range: 0-255/ Unit: 1000ms)
