Enter 162 End
*/$%ENTR* *ZEND*
Setting up your Operation Modes
7
7-4-1-10.
Set Retransmission Count for SPP
To avoid data transmission loss, messages sometimes have to be resent due to a failure to
receive
ACK signal. This parameter allows you to configure the number of attempting
retransmission if the associated operations are performed using RS-232 or USB COM
interfaces.
Procedure
(1)
Scan
Enter
barcode.
(2)
Scan
BtSppTxAckCnt
barcode to configure timeout parameter for SPP.
(3)
Please refer to Decimal/Hexadecimal Table in the appendix to scan decimal value
barcodes representing the desired value in the range of 0 to 255. For instance, to
set retransmission count to 1, then scan
1
to assign the specified decimal value
“1”.
(4)
Scan
SET
barcode to complete the variable-binding operation.
(5)
Scan
End
barcode to complete the configuration.
*ACEE0*
BtSppTxAckCnt
ACEE0
(Length: 1 digit / Range: 0-255/ Unit: 1000ms)
