Enter 104 End
*/$%ENTR* *ZEND*
6. Memory / Bluetooth / Cable General Setting
6-2-18Scan Idle Time
The device will switch to power-saving mode after remaining idle for a while.
This parameter is thus used to specify the length of time allocated for the
scanner to elapse before power-saving mode is initiated.
*3QM+*
Configuration Range
Unit
Default Setting
1 ~ 255 Secs
1 Sec
15 Secs
Procedure
(A) Scan “Enter” barcode
(B) Scan “Scan Idle Time” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
6-2-18 Scan Idle Time
