Enter 58 End
*/$%ENTR* *ZEND*
5. General Setting
5: General Configuration Setting
5-2-2-3 Command Mode
Scan the appropriate barcode to enable or disable Command mode for SPP
.
*7880*
Disable
*7881*
Enable
5-2-2-4 Retransmission Count
To avoid data transmission loss, messages sometimes have to be resent due
to a failure to receive ACK signal; when the amount of resending is out of
range and STILL not yet received ACK, which means Timeout
*58O+*
Configuration Range
Default Setting
0 ~ 255
2
Procedure:
(A) Scan “Enter” barcode
(B) Scan “Retransmission Count” barcode
(C) Scan parameters from Hexadecimal / Decimal table
(D) Scan “OK“ barcode
(E) Scan “End” barcode
