OPERATION
1. Slide boot onto arms, large end first. The arms
should just protrude from the small end of the boot.
To fit a boot to an inner joint, turn the boot inside out
before sliding it onto the CV boot installation tool’s
arms.
2. Press “+” button until arms open enough to pass
over the joint. Keep hands clear of moving parts.
3. The air line can now be disconnected. The arms
will remain open until the Minus button is pressed.
4. Place this tool over CV joint and press release
Minus button . Keep hands away from moving parts.
5. Slide the boot from this tool onto the axle and
withdraw the CV boot installation tool over the joint,
leaving the boot in position. Complete the
installation in the normal way.
Maintenance
Do not attempt to clean or repair the CV boot installation tool whilst air line is connected.
There is no routine maintenance on this tool. Only use genuine spare parts obtainable from
your supplier.
Summary of Contents for NEILSEN CT4887
Page 2: ......
Page 7: ......
Page 8: ......
Page 9: ...CANNON TOOLS LTD Add 20 station road Rowley Regis west midlands B65 0JU U K Made in China ...
