52
| CAV 4.1 Operation Manual
6.
Click
Run
. The
Select Trays
window opens.
7.
Select the trays to run. Click
OK
.
The CAV 4.1 begins running the selected trays. Additional samples
may be added to the trays until the run completes.
•
Pause
—opens a selection window. Pausing a tray "Now" immediately halts all actions for that
tray. If a test is halted prior to the start of the wash cycle, the data for that sample is discarded.
•
Resume
—opens a selection window to resume operation for selected trays.
•
Abort
—opens a selection window to abort all activity for selected trays.
8.
When each test completes, the measured KV is shown in the
Sample Action
field. Once the entire
test run finishes, the tray pauses. No additional samples may be added to the run. Click
Resume
to
clear all data for the active tray.
View Test Results (
VISCPRO II
)
Data obtained during sample testing is temporarily displayed in the
Sample Action
field and
permanently stored in the database, which may be viewed by opening an analysis package.
Tests must finish running before they can be viewed. The entire tray does not need to have finished, but
individual results are only available in the database after they have completely finished.
1.
In the
VISCPRO II Menu
, select
Analyses
>
View Analysis
. The
Choose Analysis
window opens.
2.
Open
Basic Package
and select
CAV Data Table
.
3.
Select the
Open Select Analysis Configuration
radio button.
4.
Select an analysis and click
OK
.
