Cannondale 2012 RZ ONE TWENTY, Owner'S Manual Supplement

6

68mm 

A

D

A

PTE

R

 I

N

ST

A

LL

A

TIO

N

The following procedure should only be completed by a professional bike mechanic.   

The adapter IS NOT a repair part 

and will only work in undamaged frames in good condition.

1.   Remove the BB30 bearings and circlips  from the bottom bracket shell. 

2.  Thoroughly clean and dry the inside of the bottom bracket shell.    Remove any grease or dirt.  Use a clean lint-free shop towel 

dampened with alcohol to finish.

3.  Apply Loctite™ 609  carefully to the bearing seat positions on both side of the inside  shell.   

4.    Clean the outer surface of the adapter.  Use a  clean shop towel dampened with alcohol.

5.    The groove side of the adapter must be located on the drive side.  With a headset press, press the ADAPTER until the groove side 

face is flush with the drive side face of the SI BB shell.

A

llow at least 12 hours (at 72°F) for the Loctite to cure before installing the standard bottom bracket crankset.  

Follow Loctite Technical Data Sheet 

http://tds.loctite.com/tds5/docs/609-EN.PDF

Groove

KP009/

68 mm ADAPTER

D

R

IVE SIDE

(Headset press not shown)

KF368/

ADAPTER w/TOOL

Loctite™ 609

N

OTICE

We strongly recommended that you use a swab to control the application and avoid spillage of the Loctite.  Prolonged contact 
with the frame finish may result in discoloration or damage.  Be sure to immediately wipe up any spills and remove any 
compound in contact with the painted surfaces.