12.
FRONT DERAILLEUR
Run cable housing from the front shifter to the housing stop on the right
side of the downtube. Run exposed cable to the housing stop a the lower
end of the downtube. Run cable housing (approx. 32cm.) from this down-
tube stop, under the bottom bracket, and to the housing stop on the
swingarm just behind the rear suspension pivot. Be sure to leave enough
slack in this piece of housing to allow for the movement of the swingarm.
It is easiest to first position the housing into the stop on the swingarm,
and then to run the cable through the housing and out the hole towards
the front derailleur.
REAR DERAILLEUR
Run cable housing from the rear shifter to the lower slot in the double
housing stop on the left side of the downtube. Insert the included plastic
cable stops in each of the top through guides, with the large openings
facing out towards the cable housing, away from the center of the down
tube. Run exposed cable down to the lower housing stop on the left side
of the downtube (see Fig. 7). Run cable housing from this stop, under
the rear shock and the seat area, across to the housing stop insert on
the right side of the swingarm, under the cantilever brake stud. Run
bare cable to the rearward housing stop on the swingarm. Run cable
housing from the rear housing stop on the swingarm to the rear derailleur.
Fig.7
▲
Rear Derailleur
Rear Brake