9
126560.PDF
d
c
8
b
2
4
3
6
a
a
4
b
b
NOTICE
Incorrect assembly (pivot/shim) can result in linkage play,
accelerated wear, or damage.
Do not over-tighten. Use a torque wrench.
Be sure to loosen the pinch bolts of link before assembly.
Before assembly, inspect all bearings for good condition. Replace if necessary.
Clean and apply Loctite 242 (blue) to the pinch bolt threads. Tighten to 5 Nm, 44 InLbs.
Clean and apply light grease to pivot axles and main shims.
Insert DT Link Axle and SS Lever axles from opposites side of the link as shown.
Use KP169/ tool to install pivot and main shim together. Make sure both are seated against bearing inner race before tightening
pinch bolts. Adjust the pivots with the tool so the gap between bearing and link is the same on each side.
Route cables correctly around pivot. See
Cable Routing
.
Summary of Contents for Jekyll
Page 27: ......
