16
Setting Sag:
1.
Set shock to the FLOW - 150 mm (long travel)
mode with the remote lever.
In this mode, the
sag you set will be 100%. When the DYAD RT2 is
switched to the ELEVATE - 90mm mode , the sag is
automatically reduced to 60%.
FLOW mode
(long travel)
150 mm
FWD
ELEVATE mode
(short travel)
90 mm
2.
Remove
negative air valve cap.
Connect the pump (Cannondale
1MP01/SLV
) to
the negative air pressure valve, press and hold
the release button to release all air pressure.
Replace the valve cap.
4.
Remove
positive air valve cap. Attach the
pump to positive air valve.
Set positive air pressure for your weight according to
the
DYAD RT2 Recommended Air Pressure
table.
Replace the valve cap.
5. Again,
attach pump to
negative air chamber
valve and set negative air pressure for same
weight.
Replace the valve cap.
After setting sag, you find that you want more or less
sag, choose the next lighter or heavier rider weight
range from the table. Repeat steps 1-5 again.
Left-hand lever set-up shown here.
Summary of Contents for Jekyll
Page 27: ......
