7
126560.PDF
35 mm
5 m
m
4 m
m
1
2
13
14
12
13
1
600mm SRAM
650mm Shimano
155mm
Note orientation of DT clamps.
Small plate should be positioned
under the housing (parallel with
lines) with the rounded sides up
as shown. It is not side-specific,
however.
NOTICE
Incorrect clamp placement
can result in damage. Do not
over-tighten the clamp bolts.
Check for sufficient housing cable loop. Its about 35mm as shown above.
Inadequate loop can result in ghost shifting or housing ends pulling out of down
tube when the bike is at full travel.
Its best to determine housing lengths with the shock out of the bike. That way you
can move the swing arm through the travel and actually see what the cable housing
is doing. It always looks like there is too much cable housing when set up properly.
Photo shows crossing housing to prevent the rear derailleur housing contacting the
chainring. Or, a cable tie can be used.
Be sure to install nose end seals and rubber seal at the housing ends as shown.
Summary of Contents for Jekyll
Page 27: ......
