9
133422.PDF
3.
2.
7.
5.
2.
2.
4. 4.
6.
1.
(a)
2.
Carbon Link:
Install
bearings w/Loctite
401 Prism Instant
Adhesive *
Alloy Link:
Install bea-
rings w/Loctite 609
shoCK lInK
1. Clean outer race of all bearings and link
bearing bores with denatured alcohol and
clean cloth to remove any oil or contamina-
tion
2. Apply a thin bead of Loctite 401 Prism
Instant Adhesive * around inside of a
bearings bore near the outer edge of the
bore.
3. Insert a bearing into the bore with adhesive
and ensure it is fully seated on the lip (a) in
the bore.
4. Ensure bearing is fully seated in bore.
5. Repeat steps 3-5 for the remaining 3
bearings.
76 Confirm that all 4 bearings are fully seated
in each bore.
7. After 45 seconds the adhesive will cure
enough for handling
8. Wait a 5 minutes before installing link in
frame
1.
Shock Link
2.
Bearing 4X
3.
Frame Pivot Bolt
4.
Spacers 2X
5.
Frame Pivot
6. & 7. Shock Mounting Bolts -
KP433/
Composite link bearing Installation
* Required, no substitutions
