11
133422.PDF
M6
1.0 N-m
1.
a
M5
T25
3.0 N-m
2.
4.
3.
5mm
A
loCK’r
removal
The axle removal technique is shown removed from
for clarity. See inset A.
steps:
A. Loosen the screw (4) 4-6 turns using a T25 Torx
key.
B. Tap head of M4 screw (4) to un-seat threaded
wedge (2).
Remove M4 screw (4) and threaded wedge (2)
from the axle (1).
C. Insert a 5mm hex key to twist the wedge (3)
free and remove it (shown). If stuck, insert the
long side of a 6mm hEX key (non-ball end) from
the threaded end of axle and tap it out.
D. Insert a 6mm hex key into the axle and turn
counter-clockwise until it can be removed.
Installation
Be sure to inspect the parts for any burrs, scratches
or other damage before assembly. Replace the
complete axle assembly if any damage is found.
•
Apply a high-quality bearing grease to all the
parts of the assembly before installing into
the linkage. Be sure to coat all threads, wedge
surfaces and expansion areas.
•
Be sure to use the correct length axle and
screw for the specific location. See above.
•
Insert the axle (1) into the link from the
non-drive side. and tighten it with an 6mm hex
to 1.0Nm. Do not over-tighten.
•
Insert the threaded wedge (2) into the drive
side of the axle and insert the other wedge (3)
and screw (4) opposite and tighten screw with
a T25 Torx to 3.0Nm.
Clean and apply
light grease to all
parts.
