1
KP065/
chainstay protection
the chainstay plate (KP065/) located on the right chainstay just behind the chain rings, protects
the chainstay from damage in the event the chain is dropped from the chain ring. Contact your
Cannondale Dealer for a replacement if it is becomes missing or damaged. the clear chainstay
protector (above right) provides limited protection against frame or finish damage caused by
the chain. replacement protectors are available through a Cannondale Dealer.
rear derailleur
hanger
Before re- installing (same or new): Clean
dropout and inspect carefully for any cracks or
damage. Clean surfaces and apply a light film
of bike grease to the dropout to minimize any
noise or “creaking” that might result from very
slight movement between the dropout and
hanger during movement of the derailleur.
apply grease and loctite carefully. Do not
contaminate the male or female bolt threads
with grease which would cause the loctite to
be ineffective.
Check derailleur adjustment after
replacement. readjust wheel quick release
so it is very tight. see Part i section 4. a in
your Cannondale Bicycle owner’s manual.
KF096/
2.5 mm
Loctite 242 (blue)
1.1 Nm, 10 InLbs
LIGHT
GREASE
CAUTION
DO NOT USE A DERAILLEUR HANGER
ALIGNMENT TOOL TO STRAIGHTEN.
