14
134911 Rev 1.
ENGLISH
SYNAPSE - OWNERS MANUAL SUPPLEMENT
Di2 Battery Seat Post Installation
4mm
(a)
2
65mm
1
(b)
KF115/ - Carbon Gel
5 Nm
A
B
The Shimano Di2 battery fits within the inside diameter
of the seat post.
The battery is retained by the placement of specifically
sized O-rings on the outside of the battery as marked by
the Cannondale label applied to it.
The O-rings, when installed properly are sufficient to
retain the battery. See the table above.
To install the O-ring:
Select the correct size O-rings for the seat post in use.,
Clean the outside of the battery surface with a clean lint-
free shop towel. Also clean the inside of the seat post.
Position the three O-ring on the label surface as
indicated.
Insert the batter and O-rings into the bottom of the seat
up to the “STOP Insert” red line limit.
When installing the battery fitted seat post into the
frame, make sure there is adequate slack in the harness
wiring to enable removal or seat post adjustment.
NOTICE
•
Do not use any cleaners or solvents on the
battery or seat post.
•
It is important that you DO NOT use grease or
other lubricants which will cause the O-rings
to slide.
•
When installing the battery fitted seat post
into the frame, make sure there is adequate
slack in the harness wiring to enable removal
or seat post adjustment.
